Use and Care Guide

MODULAR SCREED SYSTEMS

System Accessories

Edge Strips for Conventional Screeds

Schluter

-BEKOTEC-BRS is an edge strip made of closed-cell polyethylene

foam with an integrated foil leg. The edge strip is positioned at floor/wall tran-

sitions or fixed building elements, with the foil leg placed onto the substrate

below the BEKOTEC panel or over the polyethylene covering sheet.

Schluter

-BEKOTEC-BRSK is similar to BEKOTEC-BRS, but features an adhe-

sive strip that allows the foam to be bonded to walls or other fixed building

elements for ease of installation.

Roll: 4" x 164' (10 cm x 50 m)

Thickness: 5/16" (8 mm)

Edge Strips for Poured Screeds

Schluter

-BEKOTEC-BRS/KF is an edge strip made of closed-cell poly-

ethylene foam, with an adhesive strip on the backside for fastening it to the

wall and an adhesive leg for adjoining the studded panel. Placing the

BEKOTEC studded panel onto the adhesive leg creates a connection that

prevents poured screeds from flowing beneath the board.

Schluter

-BEKOTEC-BRS/KSF is similar to BEKOTEC-BRS/KF, but is

designed to be self-supporting rather than bonded to walls or other fixed

building elements.

Roll: 3-1/8" x 82' (8 cm x 25 m)

Thickness: 5/16" (8 mm)

Hydronic Tube Clamps

Schluter

-BEKOTEC-THERM-RH 75 is a PVC clamp used to attach radiant

heating tubes to the Schluter

-BEKOTEC-EN/US/P expanded polystyrene

foam studded panels. While the cut-back design of the studs ensures that

tubes are securely held without clamps in straight runs, clamps may be

necessary where the tubes are turned into a relatively tight radius.