Instruction manual

4.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to

defaults. The only one exception is ribbon sensitivity, which will note be

restored to default.

Printer initialization is activated by the following procedures.

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED turns green after 5 amber blinks. (Any green

will do during the 5 blinks).

 The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks) 

green/amber (5 blinks)  red/amber (5 blinks)  solid green

Printer configuration will be restore to defaults as below after initialization.

Parameter Default setting

Speed TTP-245, 127 mm/sec (5 ips) (203DPI)

TTP-343, 76 mm/sec (3 ips) (300DPI)

Density 8

Label Width 4.25” (108.0 mm)

Label Height 2.5” (63.4 mm)

Sensor Type Gap sensor

Gap Setting 0.12” (3.0 mm)

Print Direction 0

Reference Point 0,0 (upper left corner)

Offset 0

Tear Mode On

Peel off Mode Off

Cutter Mode Off

Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit

Code Page 850

Country Code 001

Clear Flash Memory No

Note：

Always do gap/black mark sensor calibration after printer initialization.