Instruction manual

16
Fig. 23 Remove 6 screws from lower inner cover
5. Place the printer upside down and unscrew the two screws of the hinge
holder on the lower cover. Unscrew the screw of the memory card cover.
6. Use both thumbs to hold the lower cover and index fingers to lift up the top
cover open levers to separate the lower inner cover and the lower cover.
7. Arrange the cable through the bezel. Connect the cutter module cable to
the 4-pin socket on printer PCB.
Fig. 24 Cutter module installation
PCB
4-pin Socket
Cutter Cable
Cutter
Lower Inner Cover
Lower CoverCutter Cable
Bezel