User guide

FRED easyport TRAINER
User guide
Page 27
6 Scenario selection procedure
6.1 List of available scenarios
Scenario 0 SNR
Scenario 1 SNR / SR
Scenario 2 SNR / SR / SNR
Scenario 3 SR
Scenario 4 SR / SNR
Scenario 5 SR / SNR / SR
Scenario 6 Elect fault / SR
Scenario 7 SR/ Elect fault / SR
Scenario 8 SR / SR / SNR
Scenario 9 Infrared control function
Notes :
SNR Shock not recommended
SR Shock recommended
Elect fault Electrode fault
The last step of each scenario is indefinitely repeated.
6.2 Selection of a scenario on the device
• Keep the orange SHOCK button (3) pressed while putting the device On with the green On/Off
button (1) to access in the configuration menu.
• The selection in a menu is made by the blue ANALYSE button (2); the passage to the next step
in made by the orange SHOCK button (3).
• Line 1: functioning mode of the device
• Line 2: choice between automatic and manual analysis
• Line 3: selection of one of the scenarios (0 to 8) or selection of the remote control (scenario
9).
• Line 4: saving of the selected configuration with the blue ANALYSE button (2): the device
goes Off.
Note: pressing longer than 3 seconds on the green On/Off button (1) puts the device Off without
saving the settings.
The device can then be switched on normally and it will operate according to the selected scenario.