DESKTOP SPEAKER AMP
4 2 CONNECTIONS 1 3 1 Connect your source to the Rekkr’s “IN” RCA jacks with high-quality RCA cables. “Source” is a fancy word for headphone amp or, preamp, or any other device that has volume-controlled audio output. 2 Connect the supplied wall-wart cable to the jack labeled “AC IN.” Do not use any other wall-wart, or Rekkr will not work.* 3 Stereo: Connect the speakers to the “L” and “R” outputs using banana plugs. Ensure that the two switches on the bottom are not set to “MONO.
OPERATION 6 1 Turn it on. The front LED will light up, and the relay will click in after about 10 seconds. Then you’ll have music! 2 Control volume with your headphone amp or preamp. You need a source with a volume control. Don’t turn it up until it distorts, or until your ears bleed. PROTECTION If your Rekkr clicks and mutes, clicks and mutes, over and over, it is protecting itself from over-current or over-temperature situations.
(And maybe some stickers, and the appreciation of the production, QC, and engineering staff at Schiit Audio in Texas and California.) SAFETY IN THE BOX WARRANTY (1) Rekkr (1) Wall-Wart 6VAC, 2A 1. If you don’t know how to install audio devices, get a qualified professional to help. 2. Never use this device near water, do not expose to rain or moisture, and clean only with a dry cloth. 3. Assure adequate ventilation, do not block ventilation openings, or place near heat sources. 4.
