Specifications

Page -6-
ASSEMBLY INSTRUCTIONS
Figure 3
Figure 4
Figure 5
Step 4
Insert Manifold into Pole Support (Figure 5 & 6).
Insert the Manifold Assembly through the Post by
passing through the hole in the Post Support.
NOTE: Make sure the hose and regulator assembly
attached to the manifold is never bent or kinked during
the installation and operation of the heater.
Figure 6
Secure Pole Support to Legs using (6) Large Bolts. (6)
Lock Washers and (6) Large Nuts per leg. Wrench
tighten the nuts and bolts from Step 1. (Figure 3)
Step 2
Step 3
Attach Ballast Weight to Base using (1) Long Bolt, (1)
Large Lock Washer and (1) Large Nut. (Figure 4)
Models
SPC-54PHW SPC-54PHB SPC-54PHT SPC-55PHS