Manual

22
Now you stored a permanent setting: servo ch 12 out, if you use 12channels.
Power off, Remove jumper, Connect your servos, Test all works.
if you use under 12ch, you will off course always get PPM out of the ch12 connector,
after a setting change, or PPM timing change or number of channels assigned, you must always perform a
bind, and store failsafe, and test all settings works.
Channels on Normal Range
Notice a channel 9 and 10 on the board if you wish to get more of you receiver. Connect your power and
ground to one of the other channels pins and then solder the servo control to the 9 or 10 channel pad.