Manual

21
Special Features Configurations
The receiver can be configured to do a few things other than normal.
HOW to configure (if you don’t need to configure, just power it up as normal)
POWER OFF
connect a 2.54mm 2 pin jumper (a short circuit connection)
on servo channel 6-7 (YES between the two signals, they are now shorted together)
Power up the RX
See LED D1 is lit, this one is closest to same side as ch6
Now you stored a permanent setting: PPM out even if you use 12channels.
Power off, Remove jumper, Connect your servos, Test all works.
POWER OFF
Connect a 2.54mm 2 pin jumper (a short circuit connection)
on servo channel 7-8 (YES between the two signals, they are now shorted together)
Power up the RX
See LED D2 is lit, this one is closest to same side as ch8