Instructions

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

• If the connection cable of this unit is damaged, it must be replaced by the manufacturer

or their service department or a similar qualied person in order to avoid hazards. The

voltage of 230 volts AC indicated on the type plate of the pump must correspond to the

mains voltage present.

• Never lift, transport or fasten the pump by the mains cable.

• Make sure that the electrical plug connections are located in a ood-proof area or are

protected against moisture.

• Before any work on the pump, pull out the mains plug.

• Ensure that the pump is not exposed to a direct water jet.

• The operator is responsible for compliance with local safety and installation regulations

(ask a qualied electrician if necessary).

• The user must implement suitable measures (e.g. installation of an alarm system, re-

serve pump or similar) to prevent consequential damage caused by ooding of rooms in

the event of pump faults.

• If the pump fails, repair work may only be carried out by a qualied electrician or by cus-

tomer service.

• Only use original spare parts.

• The pump must never be allowed to run dry or be operated with a fully closed suction

line. Damage to the pump caused by dry running will invalidate the manufacturer’s war-

ranty.

• The pump must not be used for swimming pool operation.

• The pump must not be installed in the drinking water circuit.

Remaining hazards

The machine has been built using modern technology in accordance with recog-

nized safety rules. Some remaining hazards, however, may still exist.

• Injury through electric current if incorrect electric connection leads are used.

• Even when all safety measures are taken, some remaining hazards which are not yet

evident may still be present.

• Remaining hazards can be minimized by following the safety instructions as well as the

instructions in the chapter Authorized use and in the entire operating manual.

• Health hazard due to electrical power, with the use of improper electrical connection

cables.

• Release the handle button and switch o󰀨 the machine prior to any operations.

• Avoid accidental starts of the machine: Do not press the start button while inserting the

plug into the socket.

• Use the tools recommended in this manual to obtain the best results from your machine.

• Always keep hands away from the work area when the machine is running.