Operation Manual

29
3 Bring the jack into the transport position and lock the
saw in this position with the locking lever.
4 Remove the hex nut (A) and the recoil spring (B).
5 Loosen the locking lever and grasp the jack rmly so
that it does not fall down and the recoil spring cannot
jump out of the unit in an uncontrolled fashion.
6 Tip the jack carefully back and place it on the ground.
7 Take the key (g. 13, right side) in order to stopback
the ange, use the saw blade key (g. 13, left side)
to open the hex nut and remove the ange.
8 Carefully remove the saw blade. Wear protective
gloves for this part of the work. (Attention: there is
danger of injury, so please take caution!)
9 Before replacing the saw ange, clean the ange with
a cloth or soft brush.
10 Replace the saw blade and ange and tighten the
ange nut.
11 Make sure the jack with the spring coil is properly
placed and tighten the hex nut once again properly.
12 Test the functionality of the rocker.
ATTENTION ! Observe the correct direction of rotation
when inserting the saw blade.
Adjustment of the jack stop, Fig.16
Set the entry point of the jack with the adjustment screw.