Instructions
www.scheppach.com
GB
|
29
Please provide the following information in the
event of any enquiries:
•
•
•
Service information
Please note that the following parts of this product are
parts are therefore also required for use as consum-
ables.
Spare parts and accessories can be obtained from our
cover page.
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit.
The raw materials in this packaging can be
material, such as metal and plastic. Defec-
tive components must be disposed of as
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
disposed of at a designated collection point. This can
electronic equipment. Improper handling of waste
-
ardous substances that are often contained in electri-
-
tive use of natural resources.
15. Maintenance
Attention!
-
nance work on the equipment.
We recommend:
• The splitting wedge is a wearing part that needs to
be sharpened or replaced after wear.
• The combined gripping and controlling device must
remain smooth running. Lubricate with a few drops
• Keep splitting wedge drive clean of dirt, wood shav-
ings, bark, etc.
• Lubricate slide rails with grease.
When must the oil be changed?
Change the oil after 150 working hours.
Oil change (g. 17 - 20)
1. Move the log splitter into the start position and pull
out the mains plug.
2.
3. Turn the log splitter on the support leg side as
Dis-
manner!
4. machine on the motor side as shown in
5. Clean the oil drain screw with dipstick (8) and
screw it back in to the machine that is still in a ver-
6. Now screw the oil drain screw with dipstick back
splitting log several times.
7. Check the oil level one last time and top up with a
little oil if required.
Dispose of the used oil in a correct manner at a
public collection facility. It is prohibited to drop
old oil on the ground or to mix it with waste.
Connections and repairs