Instructions
www.scheppach.com
GB
|
27
causes the pressure plate to retract.
If a piece of log to be split cannot be split within 5 sec-
-
for more than 5 seconds can pose a risk of overheating.
10.4 Hoist limiting
It is reasonable to limit the hoist of the pressure plate
(10) for short splitting material. Thereto press the con-
trol lever (12) and the release button (6) and let the
material.
limiting ring (7a) to the housing and tighten it. After-
The pressure plate will now be resting in the selected
position.
10.5 Wrongly placed log (g. 13)
work table. Make sure logs will not twist, rock or slip
on the upper part. This will break the blade or damage
the machine.
Do not attempt to split several pieces of logs at the
10.6 Jammed log (g. 14 + 15)
cause accident.
1.
2.
stops at its starting position, insert a wedge wood
3. Start the log splitter to push the wedge wood under
4.
11. Electrical connection
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
4. Fasten the guards (E + F) together using two Phil-
lips head screws, clamping brackets and nuts.
m IMPORTANT!
10. Initial operation
-
•
(cracks, cuts etc.).
•
•
•
• the oil level and
•
10.1 Checking the oil level (Fig. 17)
pump and control valve. Check the oil level regular-
the oil pump. The oil level must be within the middle
mark on the dipstick. The machine must stand on level
oil level.
10.2 Ventilation screw
machine, the bleed screw (7)
being compressed after being decompressed. Such
continuous compression/decompression will blow out
machine.machine,
make sure the bleed screw is tightened to avoid oil
leaking from this point.
10.3 Splitting logs
this, proceed as follows:
1. Place the log plain onto the work table (9).
2. Your machine is equipped with Two-hands Control
of the user – left hand controls the control lever (12)
while right hand controls the push button switch (6).
3.
splitting action.