Instructions
www.scheppach.com
26
|
GB
9.2 Installing the handle (4)
(enclosed accessories bag a) (g. 5)
screws.
9.3 Installing the protective guard (L)
(enclosed accessories bag b) (g. 6 + 7)
1. Fit the protective guard (L) to the trunk guide plate
2. -
cated on the wheel bracket.
3. Fasten the other end of the strut to the protective
guard using the Phillips head screw and nut. (3)
4. Now guide the open end of the strut (O) between
-
9.4 Installing the tray table (K + M) (enclosed
accessories bag c + d + e) (g. 8 + 9 + 10)
1.
splitter. (1) Ensure that the table and the protective
guard are level in relation to each other.
2.
3. Fasten the other end of the strut to the protective
guard using the Phillips head screw and nut, align
4. Now guide the open end of the strut (N) between
the screw and the foot bracket, tighten the screw
5.
6. Align both tables in relation to each other and use
9.5 Installing the guard (E - J)
(enclosed accessories bag f) (g. 11 + 12)
1. Connect the guards (H) and (I) together, use two
Phillips head screws, clamping brackets and nuts
2. Fasten the guards (H, I, J) to the holes provided for
this. These are on the side of the table and the pro-
tective guard. Fasten the guard with seven Phillips
head screws, clamping brackets and nuts. Fit the
protective guard (G) to the control lever protection
(11) and use a Phillips head screw and a nut to
3. Now fasten the guards (E + F) on the top. Fasten
them with eight Phillips head screws, clamping
brackets and nuts.
8. Unpacking
• Open the packaging and remove the device care-
• -
aging and transport bracing (if available).
•
• -
port damage.
• In case of complaints the dealer must be informed
-
cepted.
•
period has expired.
•
with the device prior to using it.
•
wearing and spare parts. Spare parts are available
-
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, lm and small parts! There is a risk of swal-
lowing and suocation!
9. Attachment / Before starting the
equipment
At least two people are required to install the de-
vice.
9.1 Installing the base frame (g. 3 + 4)
-
Therefore, use the hexagon screws M6 x 16 with the
nuts provided.
1.
2. Connect all single parts of the base frame with the
machine.
3.
under the riving knife side.
4. Fit the wheels onto the wheel axles of the base
frame.