User Manual

21
Fig. 1
Content/ Description/ Amount
dp 16 sl
7
Chuck protection
1
8
Vice
1
9
Fastening screws
4
Remove the protective oily coating on the machine table.
Use this traditional household grease or stain.
Warning:
To prevent fire and carbon monoxide poisoning, never use
gasoline, petroleum or similar flammable materials.
Protect the table, the column and the surface equipment
through a protective wax coating from rusting. Wipe all
parts thoroughly with a clean, dry cloth.
Equipment
1 Base plate
2 Pillar
3 Drilling table
4 Machine head
5 Laser
6 Toothed rack
7 Keyless drill chuck
8 Grips
9 Drill chuck protection
10 Depth stop
11 Motor
12 On-Off switch
13 Belt protective hood
14 Vice
ASSEMBLY INSTRUCTIONS
WARNING:
For your own safety never connect plug to power source
outlet until all assembly steps are completed and you
have read and understood the safety and operational in-
structions
Column to base, Fig. 2
1 Position base {A) on floor or bench.
2 Place column assembly {B) on base and align holes
in column support with holes in base.
3 To attach and fasten the pillar unit, screw the three
(or 4) screws (a) into the base plate and tighten them
with a wrench.