User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
20
|
GB
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply with
these regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection condi-
• Given unfavorable conditions in the power sup-
• -
nection points that have a continuous current-car-
• -
-
-
quirements.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
-
AC motor
• The mains voltage must be 220 - 240 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Please provide the following information in the event
9. Maintenance and Care
Before each maintenance and cleaning work:
•
• wait for standstill of the beater
• pull out power plug
-
expected damages and injuries.
-
-
of the reach of children.
the machine:
• Keep vent slits clean and free from obstructions.
• Remove dust and dirt using a cloth or a soft brush.
• Do not clean the machine with running water or
highpressure cleaners.
•
parts.
•
• Clean the beaters.
• The agitator is equipped with carbon brushes.
-
-
Check the shaft on a regular basis. An agitator with
defective shaft must no longer be used. Have the
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts* Mixing paddle, carbon brushes