User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
19
8. Technical data
Mains voltage 230 V~, 50 Hz
Power input 1400 W
Idling speed 0-570 min
-1
/ 0-760 min
-1
Mixing tool mount M14
Protection class II
Weight 4.9 kg
Sound and vibration
Sound and vibration values were measured in ac-
cordance with EN 60745.
Sound pressure level L
pA
89 dB(A)
pA
3 dB(A)
Sound power level L
WA
100 dB(A)
WA
3 dB(A)
Wear ear-mus.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value ah = 5.673 m/s
2
2
Additional information for electric power tools
Warning!
-
change according to how the electric equipment is
-
tional circumstances.
-
pare the equipment with other electric power tools.
Keep the noise emissions and vibrations to a
minimum.
• -
ing order.
•
•
• Do not overload the appliance.
•
•
• Wear protective gloves.
7. Start-up
Turning on and o
Turning on (g. 1)
Press and hold the circuit breaker (8) for the ON /
(7) to start the handheld mixer. Once the tool is run-
Turning o (g. 1)
Speed controller (g. 1)
With the speed controller (9), the power tool’s speed
mixed determines the speed rate that is required.
2- speed gear (g. 1)
The device is equipped with a 2-speed gear. If the
gear selection switch cannot be locked, turn the stir-
•
1. speed: 0 min
–1
- 570 min
–1
2. speed: 0 min
-1
- 760 min
-1
Only operate this switch at standstill of the ma-
chine.
Working with the paint and mortar mixing tool
power plug.
to ensure adequate cooling of the motor. Move the
mixing tool through the mixing container during the
mixing operation. Continue mixing until all the mate-
Area of application of the agitators (g. 1)
• The left-turning agitator (2a) is used for low-viscos-
varnishes, glazes, wallpaper paste, sealing com-
pounds, bitumen, chemicals, red lead, cement
slurries
• The right-turning agitator (2b) is used for high-vis-
cement plaster, screed, concrete, tile adhesive,