User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
7. Installation
m IMPORTANT!
Prior to use, ensure that the device has been cor-
rectly and fully assembled.
Unpacking (g. 1, 2, 3)
1 Release the locking hooks (4) and remove the ma-
chine head (2). The accessories are located inside
the stainless steel container (7). Only the plastic
extension tubes (3x) (7) are located outside the
stainless steel container, in the packaging. Remove
all of the accessories from the stainless steel con-
tainer (7).
Installing the castors (g. 4)
1. Press the four castors (5) into the holes in the cas-
tor mounts.
Installing the machine head (2) (g. 5)
1 Place the machine head (2) on the stainless steel
container (7). Secure the machine head (2) with
the locking hooks (4). When installing the machine
head (2), ensure that the locking hooks (4) latch into
place correctly.
Installing the foam lter (14) (g. 6)
Installing the paper lter bag (15) (g. 7)
bag (15) makes it easier to dispose of the dust col-
lected.
Installing the suction hose (g. 8, 9)
port, depending on the desired use, on the wet and
dry vacuum.
Vacuuming:
(8). To do so, slide the end of the suction hose (13)
into the suction hose port (8). Make sure the plug-in
the recess on the suction hose connection (8). In the
end position, turn the suction hose (13) in a clockwise
direction.
18
|
GB
Blowing:
the suction hose (13) latches into the recess on the
connection with blast function (11). In the end posi-
tion, turn the suction hose (13) in a clockwise direc-
tion.
Installing the plastic extension tubes, suction
hose and oor nozzle (g. 10)
Assemble the plastic extension tubes (18) by pushing
-
sion tubes with the bent end of the suction hose (13).
end of the assembled plastic extension tubes.
8. Operation
m WARNING!
the exhaust air during wet vacuuming.
Switching on/o (g. 1)
•
• Switch setting I: On
Dry vacuuming
Wet vacuuming
If the stainless steel container (7) is full, the safety
operation is interrupted.
m IMPORTANT!
-
ter (14) provided. To remove the liquid vacuumed up
-
chine head (2) by releasing the locking hooks (4) from
the stainless steel container (7). Pour out the liquid
residue.
9. Maintenance and cleaning
m WARNING!
Prior to any adjustment, maintenance or service
work disconnect the mains power plug!
Cleaning
It is recommended to clean the device after each use.
Do not spray the device with water or clean it under
running water. This can result in electric shocks and
can damage the device.