User Manual

www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
21
Idle setting screw (g. 3)
        

-
-
ti-clockwise.
Warning! Other work on the carburettor must be car-

8. Operation
know
and follow the safety notices.
󰀨
motor, disconnect the spark plug connector and wear
-

      
-
ered machines).




Observe national stipulations during work when us-

     
hazardous area.
Check the working environment for foreign bodies
and remove them.

󰀨
Check the earth auger for correct functioning and
its safe operating condition.

in case of emergencies.
Hold on to the earth auger with both hands when
working.

process as well.
Do not lean too far forwards when working.

not rotate in idling mode when the motor is warm.
󰀨
changes to the machine‘s behaviour.
-

Drill the hole in the ground in several sections so

Keep the auger vertical, do not twist it!



Other applications are not permitted.
7. Before operation
Assembly



Place the motor casing on a work bench. Place the

both holes are aligned.


Fuelling g. 1

Pour in the fuel mixture using a funnel.

  

Fuel mixture
The auger‘s motor is a two-stroke motor. It is driven


a research octane count of at least 91. Lubrication of

oil.
Do not mix the fuel mixture in the fuel tank. Use the
mixing container supplied or another appropriate


Use fresh, clean fuel. Water and contaminants in

Refuel in a well-ventilated area with the motor not
-

machine in a building where the petrol fumes can

      
󰀨

󰀨



Starter cord (g. 1)

Choke lever (g. 3)

the carburettor. In the position, the air-petrol-mix-
ture is enriched for the motor‘s cold start. The po-
sition is used for the operation of the motor and for a
warm start.