User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
24
|
GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE).
This product must be disposed of at a designated col-
lection point. This can occur, for example, by handing
it in at an authorised collecting point for the recycling
of waste electrical and electronic equipment. Improp-
er handling of waste equipment may have negative
consequences for the environment and human health
due to potentially hazardous substances that are of-
ten contained in electrical and electronic equipment.
By properly disposing of this product, you
are also contributing to the eective use of natural
resources. You can obtain information on collection
points for waste equipment from your municipal ad-
ministration, public waste disposal authority, an au-
thorised body for the disposal of waste electrical and
electronic equipment or your waste disposal com-
pany.
AC motor
• The mains voltage must be 220 - 240 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
13. Disposal and recycling
The equipment is supplied in packaging to preven it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
14. Troubleshooting
Problem Possible Cause Help
Motor doesn’t start
ON/OFF switch damaged.
Replace all damaged parts before you use
your machine again.
ON/OFF cable damaged
ON/OFF relay damaged
Fuse blown
Motor burnt
Contact your local service centre. Every at-
tempt to carry out a repair, can be danger-
ous if it is not done by skilled personnel.
Machine gets slower
during work.
Too much pressure put on the workpiece. Reduce the pressure on the workpiece.
Sanding belt comes o
the drive pulleys.
Belt does not run straight. Reset the track.
The wood gets burnt
during sanding.
Sanding disc or belt covered with grease. Replace disc or belt.
Excessive pressure on workpiece. Reduce pressure on workpiece.
Strong vibrations
loosely mounted tool tighten tool
defective tool change tool
spindle knocks repair at a Service-Station