User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
30
|
15. Troubleshooting
Problem Possible Cause Remedy
switched on.
Carbon brush worn.
Power cut
Check microswitch
Check fuse, check overload switch on machine.
pressed.
Check fuses.
Due to the integrated lowvoltage protection, the ma-
the voltage, the machine must be switched on again.
planing.
Planing blade blunt/worn
Overload switch has tripped
Check microswitch
Too much chip removal
Too fast feed
Switch on the motor again once it has cooled
microswitch is pressed.
thicknessing
Cutting depth too great
several passes
Speed decreases when
planing
Too much chip removal
Too fast feed
Planing blade blunt/worn
reduced speed
rough
moisture
cracked
the grain
Too much material planed at one
pass
low during thicknessing
the grain
Too much material planed at one
pass
Set the lever for the thicknessing setting to the top
position
chip ejection obstructed
Too much chip removal
chip ejection obstructed
Too much chip removal
Too fast feed
and thicknessing, chip
ejection obstructed (with
Suction performance too weak.
suction connection of at least 20 m/s.