User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
|
29
14. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
The equipment and its accessories are made of vari-
-
fective components must be disposed of as special
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
disposed of at a designated collection point. This can
for the environment and human health due to poten-
obtain information on collection points for waste
-
the disposal of waste electrical and electronic equip-
•
block and knife support.
•
them with the rectangle slots in both screw heads.
knife is done.)
• Place the knife block (24) onto the knife.
•
•
• Place the blade adjustment block (18), as shown
knife (25) touches both sides of the blade adjust-
ment block (18).
• -
ed for height.
• After a successful knife setting, all clamping screws
must be tightened
Please mind:
• Sharp planer/thicknesser knives guarantee a clean
planing surface and put less stress on the motor.
•
• The planer/thicknesser blades used on this ma-
chine are not suitable for rebating and dovetailing.
•
table. Cover the cutter block and block it with the
star grip screw.
m IMPORTANT!
knives there is a risk of injuries due to lack of control.
-
placed.
Connections and repairs
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Planer blades, motor drive belt, carbon
brushes