User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
11. Cleaning
m Warning!
service work disconnect the mains power plug!
General maintenance measures
motor.
-
ucts.
The threaded spindle for height-adjustment of the
-
bricant agent.
The table surfaces as well as the infeed and output
After a longer period of use, it is recommended to
service
Tool care:
Cutter block, clamping devices, knife supports and
-
pose, clamping devices, knife supports and knives
can be put in a common resin remover for 24 hours.
of metal.
12. Storage
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
-
ing. Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
13. Maintenance
m Warning!
service work disconnect the mains power plug!
Changing the knives (Fig 17-19)
• m
changing the knives.
• Pull the planing knife cover (9) forwards as far as
•
• Lift the knives (25) and knife block (24) from the
cutter block.
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply with
these regulations.
Important information
motor can be switched back on again.
Damaged electrical connection cable.
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
•
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
-
AC motor:
The mains voltage must be 220 - 240 V
~
.
•
cross-section of 1.5 mm
2
.
Please provide the following information in the event
•
•