User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
|
27
9.1.2 Surface planing mode (g. 20/21)
Attention! Watch out the right mounting of the
chip extractor (point 8.5)
• (Narrow workpieces see g. 21) Open the knurled
srcew (10) and slide the planer blade cover (9) as
far as the width of the workpiece requires. Then
tighten the knurled srcew (10) again.
• (Width, at workpieces see g. 20) Open the star
knob nut (4) and set the planer blade cover com-
The planer blade cover (9) covers the entire blade
roller! Tighten the star knob nut (4) again.
• Plug in the machines power cord ( Press the green
•
table (14). Slide the workpiece as far as possible
with the push stick (16) forwards towards the plan-
ing table (7) over the knives (25).
• -
•
planing table (7) and knife block after the machine
has reached a complete standstill.
•
and cover the entire length of the planing knife.
9.2 Thicknessing
m IMPORTANT!: Pull out the power plug before
work.
9.2.1 Adjustment (g. 22)
• Place the crank handle (12) on the spindle and
turn it to adjust the thicknessing table (21) to the
scale (G).
• -
ble (21) from bottom to top, i.e. crank the table fur-
Then crank the table (21) upwards to the desired
height.
9.2.2 Thicknessing mode (g. 22)
• Plug in the machines power cord. Press the green
• Place a workpiece on the thicknessing table (21).
Guide the workpiece towards the feed table (14).
• -
•
table (21) and knife block after the machine has
reached a complete standstill.
• m WARNING!
maintenance~ or repair work, disconnect the pow-
• -
• -
imum of 1.1 mm out of the knife block.
• -
•
• Never cut concavities, tenons or shapes.
•
• -
m IMPORTANT!: The surfacing and thicknessing
-
pose. The contact surface of the workpiece must be
place (e.g. using the thread in the machine base).
•
machine.
•
time, the overload switch (1) can be reset again.
• To work on long workpieces, use roller tables or
a similar supporting arrangement. Such optional
plane. Their height must be adjusted such that the
workpiece is horizontal when it is fed into and out
of the machine.
9.1 Surfacing
m IMPORTANT!: Pull out the power plug before
work.
9.1.1 Adjustment (g. 20+21)
• Turn the adjustment knob for cutting depth (13)
to set the height of the feed table. The set cutting
• Loosen the parallel stop (8) with the clamping crew
(8a). Adjust the desired angle. The adjusted angle
with the clamping screw (8a) after adjustment.