User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
26
|
• Anti-kick claws (g. 9 - pos. 20)
(25) fall back without hindrance due to their own
• Planing blades (g. 17 - pos. 25)
-
The machine may only be used if all these condi-
tions are satised.
-
dition for machining short workpieces.
Check that the stop is secure before starting the ma-
chining work.
times. Stand to the side of the machine.
a safe distance from the cutting block and from the
point at which the chips are discharged.
Do not start the planing work until the cutting block
has reached the required speed.
wood which has lots of knots or knot holes.
Secure long workpieces to prevent them tipping over
the mains plug and remove the jammed workpiece.
Set the smallest cutting size after use to prevent the
m CAUTION!
-
top using suitable screws / screw clamps since oth-
erwise there is a risk that it will tip over.
•
are identical to the mains data.
8.4 Crank handle for thickness planer chip depth
(g. 8)
•
spindle.
8.5 Chip extraction (g. 10)
•
parts (5, 5a) together and retighten the Phillips
screw.
8.6 Chip extractor - surface planing (g. 11+12)
• Set the planing knife cover cpl. (9) in the upperst
position.
• -
ing table (21) in the lowest position.
•
pins (3) outwards.
•
pins in the table. Attention! The machine won´t start
•
down again.
8.7 Chip extractor - thickness planing
(g. 13+14)
• The parallel stop (8) needs to be removed for thick-
•
•
pins in the table. Attention! The machine won´t start
9. Installation
m IMPORTANT!
You must fully assemble the appliance before
using it for the rst time!
Before each use, check the following:
•
• Locked disconnected protective equipment
(g 1a - pos. 3)
checking that the machine cannot be turned on
whenever the protective equipment is open
• Brake
Switch on the machine at the start of work and
allow the machine to reach speed. Now switch the
standstill within 10 seconds. Otherwise, there is a
defect.