User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
|
25
7. Unpacking
• Open the packaging and remove the device care-
•
packaging and transport bracing (if available).
•
• -
-
considered.
•
•
of the operating instructions manual before using
it.
•
consumables and spare parts. Spare parts can be
•
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, lm and small parts! There is a risk of
swallowing and suocation!
8. Assembly
m IMPORTANT!
You must fully assemble the appliance before
using it for the rst time!
8.1 Rubber feet (g.2)
Secure the four rubber feet (15) to the bottom side of
the equipment using the Allen screws (A) and wash-
8.2 Planing blade cover (g. 3-5)
• -
ing nut (10) on the planer blade cover (9) and the
fastening nut (6) on the swivel arm for planing blade
cover (9a).
• Push the planing blade cover (9) and the swivel arm
(9a) together.
•
•
using the fastening nut (6) and the star grip screw
(4)
8.3 Parallel stop (g. 6+7)
• Now attach the parallel stop (8) to the machine
housing and fasten it using the Allen screws (C).
6. Technical data
Number of knives 2 pieces
Cutter block rpm 9000 1/min
Dimensions
26,5 kg
Technical data – Surfacing
254 mm
2 mm
90°–135°
Surfacing table size
Technical data – Thicknessing
254 mm
120 mm
2 mm
Thicknessing table size
Drive
Consumption power P1
Subject to technical changes!
Noise
Total noise values determined in accordance with EN
61029.
Sound pressure level L
pA
..............................
pA
....................................................
Sound power level L
................................
...................................................
Wear hearing protection.
The above-mentioned noise emission values were
measured in accordance with a standardised test
procedure and can be used to compare one power
tool with another.
The above-mentioned noise emission values can
-
posure.
Warning:
• The noise emissions during the actual use of the
values depending on the power tool being used,
-
cessed.
• -
consideration (such as the times when the tool is