User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
34
|
GB
14. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, the mains
circuit breaker switched o
Arrange for inspection of the machine by a special-
ist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts
up slowly and does
not reach operating
speed.
Voltage too low, coils damaged, capaci-
tor burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by a
specialist
Motor makes exces-
sive noise
Coils damaged, motor defective Arrange for inspection of the motor by a specialist
The motor does not
reach its full power.
Circuits in the network are overloaded
(lamps, other motors, etc.)
Do not use any other equipment or motors on the
same circuit
Motor overheats
easily.
Overloading of the motor, insucient
cooling of the motor
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not appropri-
ate for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or saw
blade not suitable for use
Insert suitable saw blade