Instructions
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
29
• Use the tool that is recommended in this manual.
In doing so, your machine provides optimal perfor
mance.
• Hands may never enter the processing zone when
the machine is in operation.
•
chine prior to any operations.
6. Technical data
AC motor
Power S1 1200 Watt
Operating mode S6 25%* 1500W
Idle speed n
0
5000 min
Carbide saw blade ø 210 x ø 30 x 2,6 mm
Number of teeth 24
Maximum saw blade
tooth width
3 mm
Swivel range
Mitre cut
Saw width at 90° 120 x 60 mm
Saw width at 45° 80 x 60 mm
Saw width at 2 x 45°
(double mitre cut)
80 x 35 mm
Protection class
Weight ca. 7,6 kg
Laser class 2
Wavelength of laser 650 nm
Laser output < 1 mW
* S6, continuous operation periodic duty.
Identical duty cycles with a period at load followed by
a period at no load. Running time 10 minutes; duty
cycle is 25% of the running time.
The work piece must have a minimum height of 3
mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise
Total noise values determined in accordance with EN
62841.
Sound pressure level L
pA
99,6 dB(A)
Uncertainty K
pA
3 dB
Sound power level L
WA
112,6 dB(A)
Uncertainty K
WA
3 dB
Wear hearing protection.
About disposal facilities you can inform by your
municipal or city government.
7. Do not allow batteries to heat up!
8. Do not weld or solder directly on batteries!
9. Do not dismantle batteries!
10. Do not allow batteries to deform!
11.
12. Keep batteries out of the reach of children.
13. Do not allow children to replace batteries without
supervision!
14.
sources of heat. Do not use batteries in direct
sunlight or store them in vehicles in hot weather.
15. Keep unused batteries in the original packaging
and keep them away from metal objects. Do not
mix unpacked batteries or toss them together!
16. Remove batteries from the equipment when it will
not be used for an extended period of time, unless
it is for emergencies!
17. NEVER handle batteries that have leaked without
into contact with your skin, the skin in this area
contact with the eyes and mouth. In the event of
contact, please seek immediate medical atten
tion.
18. Clean the battery contacts and corresponding
contacts in the device prior to inserting the bat
teries.
Residual risks
The machine has been built according to the state
of the art and the recognised technical safety re-
quirements. However, individual residual risks
can arise during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
main.
• Residual risks can be minimised if the “Safety infor
mation“ and the “Proper use” are observed along
with the whole of the operating instructions.
• Do not load the machine unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the ma
chine in the processing and in cut precision.
• When cutting plastic material, please always use
clamps: the parts which should be cut must always
• Avoid accidental starting of the machine: the oper
ating button may not be pressed when inserting the
plug in an outlet.