Instructions
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
25
• Harmful emissions of wood dust when used in
closed rooms.
Please note that our equipment has not been de
signed for use in commercial, trade or industrial appli
cations. Our warranty will be voided if the equipment
is used in commercial, trade or industrial businesses
or for equivalent purposes.
5. Safety information
General power tool safety information
m WARNING! Read all safety warnings, instruc-
tions, illustrations and technical data provided
with this power tool. Failure to follow the warnings
or serious injury.
Save all warnings and instructions for future ref-
erence.
The term “power tool” in the warnings refers to your
ated (cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
b) Do not operate power tools in explosive at-
mospheres, such as in the presence of am-
mable liquids, gases or dust. Power tools cre
ate sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while op-
erating a power tool. Distractions can cause you
to lose control.
2) Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
reduce risk of electric shock.
b) Avoid body contact with earthed or ground-
ed surfaces, such as pipes, radiators, ranges
and refrigerators. There is an increased risk of
electric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet con-
ditions. Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the pow-
er tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
3. Scope of delivery
• Cross cut mitre saw
• Dust bag
• Workpiece clamp
• Allen key 6 mm (C)
• Allen key 3 mm (D)
• 2 work piece supports
• Support stand
• 2 carbon brushes
• 2 batteries (AAA)
• Operating manual
4. Proper use
The cross cut mitre saw is designed to crosscut wood
and plastic respective of the machine’s size. The saw
Warning! Do not use the saw to cut materials other
Warning! The supplied saw blade is only intended
for the sawing of wood! Do not use this blade for the
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
will be liable for any damage or injuries of any kind
caused as a result of this.
The equipment is to be operated only with suitable
saw blades. It is prohibited to use any type of cut
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be in
formed about the equipment’s potential hazards.
It is also imperative to observe the accident preven
tion regulations in force in your area.
The same applies for the general rules of health and
safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
Even when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk fac
tors. The following hazards may arise in connection
with the machine’s construction and design:
• Contact with the saw blade in the uncovered saw
zone.
• Reaching into the running saw blade (cut injuries).
•
• Saw blade fracturing.
• Catapulting of faulty carbide tips from the saw
blade.
•
necessary.