Owner`s manual

EYESHIELDS (Fig. H)

1. Assemble the eyeshield (C) to the Spark Arrestor

(A) inserting carriage head screw (B) through

the Spark Arrestor and the Eyeshield as shown.

See Figure H.

2. Assemble the flat washer (D) and Lock Knob (E)

to the carriage head screw and tighten until the

Eyeshield remains in the desired position.

See Figure H.

Fig. H

SPARK ARRESTORS (Fig. F)

1. Assemble the Spark Arrestors (A) to the front

surface of the Wheel Covers (B) with the flat

washers and pan head screws (C) as shown.

See Figure F.

2. Adjust each Spark Arrestor until the lower edge (D)

is 1/16" from the grinding wheel. Firmly tighten the

hex head screws. See Figure F.

Fig. F

WORK LIGHT

The Bench Grinder is provided with a Flexible Work

Light to assist in visibility of the workpiece.

WARNING

To reduce the risk of fire, use a 120 volt, 40 Watt or less

Track Light Bulb, Type R20, medium base or equivalent

(not included). DO NOT use a light bulb that extends

past the end of the light housing.

CAUTION: The Flexible Work Light housing will remain

hot for a few minutes after turning it “OFF”. Avoid con-

tact with housing until it is cool.

WARNING

To avoid serious injury, secure the Bench Grinder to a

solid work surface. If the Bench Grinder is not securely

mounted, it will have the ability to move or tip over

during grinding operations and possibly cause the

operator’s fingers to contact the grinding wheels.

PERMANENT MOUNTING (Fig. I )

Use the mounting pads on the base of the grinder to

firmly attach grinder to a solid work surface (hardware

not included). See Figure I .

Fig. I