User's Manual

ChipCoin
®
Processing
Car Park Management System PMS20
ChipCoin Processing Manual
2.4. Maintenance and service
2.4.1. Outside
The small number of movable parts reduces maintenance expense to the coin
feeder to a minor level. The following suggestions should, however, be heeded in
order to ensure permanent faultfree operations.
6 Article no. of chapter: 86 93538 (d)
© 2004 by Scheidt & Bachmann GmbH, Mönchengladbach (Germany) All rights reserverd. Subject to alterations. Some Illustrations and descriptions may also include special options.
c Shutter plate
d Shutter magnet
e Stopper magnet (exit, automatic pay station)
f Stopper magnet (entry)
g Reject magnet
h Reject plate
i Read/write antenna (exit, automatic pay
station)
j Read/write antenna (entry)
k Reflex coupler circuit board
l Springs for shutter, rejector plate
c
d
l
k
i
e
j
f
g
h
l
• The entire coin feeder should be checked on both inside and outside for dirt and,
if necessary, should be cleaned. Be careful, in doing so, of the shutter and
rejector magnet mechanism (d,g).
• In case of serious dirt accumulation an air pump can be used for cleaning.
• Check for the smooth working of the shutter plate (c) and the reject plate (h).
Only the spring tension (l) should be allowed to show any perceptible
resistance.
• Check for tight fit of the read/write antenna (i,j).