User's Manual
Table Of Contents
ChipCoin
®
Processing
Car Park Management System PMS20
ChipCoin Processing Manual
3. Entry hopper
The entrance hopper stores the ChipCoins and conveys them to the coin feeder. In
order to increase its capacity and to make refilling easier, a funnel has been
mounted on top of the hopper. In order to check the supply of ChipCoins, the funnel
has been provided with viewing holes.
Control and voltage supply occur via a connection to the ChipCoin interface.
Coin output occurs via a chain. In order to ensure that the coins reach the right
properly start-position for transport via the chain, with every movement of the chain
there occurs additionally the movement of one of the slides driven by an eccentric.
Both the chain and the slide are driven by the same motor.
3.1. View
Front view Side view
8 Article no. of chapter: 86 93538 (d)
© 2004 by Scheidt & Bachmann GmbH, Mönchengladbach (Germany)
All rights reserverd. Subject to alterations. Some Illustrations and descriptions may also include special options.
Connection plug for
ChipCoin interface
Drive motor
Sliding shaft
Funnel receptacle /
ChipCoin input
ChipCoin exit to coin feeder
ChipCoin drive track
Name plate