User Manual

n Systems for Car Parks and Leisure Centres

ChipCoin Processing Manual

6 Article no. of chapter: 86 93538 (c)

2.4 Maintenance and service

2.4.1 Outside

The small number of movable parts reduces maintenance expense to the coin

feeder to a minor level. The following suggestions should, however, be heeded in

order to ensure permanent faultfree operations.

• Shutter plate

‚ Shutter magnet

ƒ Stopper magnet (exit, automatic pay station)

„ Stopper magnet (entry)

… Reject magnet

† Reject plate

‡ Read/write antenna (exit, automatic

pay station)

ˆ Read/write antenna (entry)

‰ Reflex coupler circuit board

Š Springs for shutter, rejector plate

• The entire coin feeder should be checked on both inside and outside for dirt

and, if necessary, should be cleaned. Be careful, in doing so, of the shutter and

rejector magnet mechanism (‚,…).

• In case of serious dirt accumulation an air pump can be used for cleaning.

• Check for the smooth working of the shutter plate (•) and the reject plate (†).

Only the spring tension (Š) should be allowed to show any perceptible

resistance.

• Check for tight fit of the read/write antenna (‡,ˆ).

†

…

„

‡

‰

‚

•