User Manual

Chapter 5
Commissioning
Figure 5-2: Installing the Battery step 1
Figure 5-3: Installing the Battery step 2
5.3 Recharge
battery
The battery can be charged in two ways. At one via the contacts on the bottom
of the unit. For this purpose, the device is placed on a charging station (cradle).
To charge the battery via the charging socket, proceed as follows.
Open the rubber covers, under which the charging soccer is located. (see
Fig. 5-4)
Plug the power supply cord into the charging socket.
Please use exclusively the charging options provided by Scheidt &
Bachmann (power supply and Cradle).
If using, power supplies do not meet the specifications, the unit may be
damaged.
When the battery is fully charged, disconnect the charger cable and close the
rubber cover.
The unit can not be loaded via the micro USB connector.
The micro USB connector is used exclusively for data exchange.
guiding rails
guiding rails
KLICK