User Manual

Chapter 5
Commissioning
Edit: Stevens Art.#.: 86 -----, Version 1.8 Date:15.06.2016
5-1
Fare collection
systems
Chapter 5 Commissioning
 For the first commissioning, the following steps are necessary
 Inserting a micro SIM card (see Chapter 5.1)
 Inserting the SAM card/s for the Smart Card Reader (see Chapter 5.1)
 Insert a microSD card (see Chapter 5.1)
 Inserting the battery (see Chapter 5.2)
 Charging the battery (see Chapter 5.3)
 Inserting a paper roll (see Chapter 5.4)
5.1 Insert SIM,
SAM, and
micro SD
Card
To insert a micro SIM, -SAM - or a micro SD card, proceed as follows:
 Open the rubber covers of the to be equipped card slot.
 Place the desired card into the appropriate card slot. (see Fig. 5-1)
All card slots have a spring mechanism that audible and tactile snaps into
place when the inserted card is properly positioned
To remove a card, push the card a little further into the card slot until an
audible and tactile trigger of the spring mechanism to be heard.
When you release the card now, it is automatically pushed out by the
spring mechanism.
This makes it possible to easily remove the card now.
 Close the rubber covers of all card slots.
Figure 5-1: Insert SIM, SAM and micro SD card
5.2 Insert battery To replace the battery, proceed as follows:.
 Insert the battery to the guiding rails and slide it over the guiding rails as far
until the battery snaps into place
SAM 1
micro SIM-Card
SAM 2
microSD Card