User manual

12
Starting operation of the outflow nozzle
Always transport/send the outflow nozzle in its original packaging, to avoid damage.
Keep the packaging material for this purpose.
Dispose of packaging material, that is no longer needed, in compliance with applicable
regulations. If you discovered transport damage you should immediately contact the
dealer from whom you had purchased the outflow nozzle.
Starting operation of the outflow nozzle
1. Plug the air hose onto the hose socket of the outflow nozzle (Fig. 4/1).
Make sure that the arrow on the check valve in the air hose points in flow direction
(towards the outflow nozzle) (Fig. 2/A).
2. Connect the air hose to a membrane air pump.
3. Connect the air hose to the power cable. Use the supplied cable clips (Fig. 2/B) for
this purpose.
4. Place the outflow nozzle on the bottom of the aquarium.
5. Connect the plug connector (Fig. 1/6) with the power supply unit (not part of the
delivery).
6. Insert the mains plug of the power supply unit into an earthing contact socket.
WARNING:
Electric voltage is highly dangerous. Make sure that the power supply unit is free of
damage before using it. The power supply unit must never come into contact with
fluids.
ATTENTION:
Incorrect voltage can damage the outflow nozzle. You should only connect the outflow
nozzle to a power supply unit with maximum 12V output.
NOTE:
Further information on membrane air pumps can be found under the following
address: http://www.schego.de.
ATTENTION:
Incorrect voltage can damage the power supply unit. Only connect the power supply
unit, if the electric voltage specified on the power supply unit complies with the
voltage of your wall outlet.
schegolux.book Seite 12 Mittwoch, 7. Juni 2006 11:10 11