Operation Manual
Instruction Manual Electrobloc EBL 101 C
3
Date: 30.09.2008
811.553 BA / EN
2 Introduction
This instruction manual contains important information on the safe operation
of equipment supplied by Schaudt. Ensure you read and follow the safety in-
structions provided.
The instruction manual should be kept in the vehicle at all times. Ensure that
other users are made aware of the safety regulations.
Y This device is not intended to be used by persons (including children)
with limited physical, sensory or mental aptitude or lack of experience
and/or knowledge unless they are supervised by a person responsible for
their safety or have received instruction from this person as to how the
device is used.
Children are to be supervised so as to ensure they do not play with the
device.
This device is intended for installation into a vehicle.
3 Operation
The Electrobloc is operated solely from the DT ... control and switch panel
connected (apart from battery isolation).
The EBL Electrobloc 101 C does not require daily operation.
Initial settings are only required after the type of battery (lead-acid or lead-
gel) has been changed or during commissioning or when upgrading with ac-
cessories (see section 3.2 and EBL 101 C installation instructions for de-
tails).
3.1 Switching system on/off
Y ATTENTION!
Incorrect Electrobloc settings.
Damage to connected devices. Therefore prior to starting:
F Ensure the leisure battery is connected.
F Ensure that the battery selector switch (Fig. 1, Pos. 1) is set to the
correct position for the inserted battery.
F Ensure that the AES fuse (Fig. 4, Pos. 16) is only inserted if an AES
refrigerator is connected to the system. Otherwise, the leisure battery
may totally discharge. Damage to the battery is possible.
Disable battery isolation on Electrobloc:
³ Move slide switch (see Fig. 4, Pos. 15) into position ”Battery ON”
³ After disabling the battery cut-off switch or after changing batteries: 12 V
main switch on the DT ... control and switch panel must be turned on
briefly to start up the consumers.
12 V main switch
(on DT ... control and
switch panel)