User manual

Operating an d Installation Instructions LT 320
2
Date: 08.01.2015 931.021 BAMA / EN
110
110
R1
100
100
94*
94*
Fig. 1 Dimensional diagram for LT 320 (dimensions in mm)
* Dimensions for furniture cut-out, installation depth including plug-in connector
approx. 35 mm
T ighten the LT 320 control panel:
 Establish an installation opening as in Fig. 1.
 Mark out the hole pattern (see Fig. 1).
 Pre-drill the holes (to 2 mm).
 Use four x 2.9 cylinder head screws.
 Ensure that the screws only gently touch against the front panel (until it is
no longer possible to move the panel).
2.2 Electrical connection
The LT 320 control panel is intended for connecting to Schaudt solar regula-
tors
F LRM 1218 (MPP regulator)
F LR 1218 (series regulator)
Appropriate 4-pin connector cables (LRM 1218) and a connector set
(LR 1218) are available for these.
Fitting