User manual

Installation instructions for solar charge regulator LR 1218
4
Date: 22.09.2009 822.212 MA / EN
Y Not all parts/cables are required for every different application.
4 Mechanical installatio n
Y This device is intended for installation into a vehicle.
The device is designed for wall or floor installation. For applications in sec-
tions 5.2 and 5.3, it must be installed in the direction vicinity of the EBL ...
electrobloc (at a maximum distance of 30cm to the front plate).
" For applications in which the cables supplied are used to connect to an
Schaudt EBL ... electrobloc, the solar charge regulator must be installed
in the direct vicinity of the electrobloc.
" For other applications, a dry and sufficiently ventilated place in the insula-
ted interior is to be selected for installation. No condensation may be able
to form on the device. In order to prevent a build-up of heat, ventilation
holes towards the living area must be provided in the upper and lower
areas of the place of installation. Its cross-section is based on the size
and average temperature of the place of installation.
" Ensure a minimum clearance to the surrounding fixtures and fittings:
F Maintain a gap of at least 5 cm on all sides (except mounted side).
F Whilst in operation, the ambient temperature must not exceed +45 °C,
measured 2.5 cm away from the sides of the device.
" On a stable and even surface, attach the solar charge regulator to the
drillholes with three screws (Fig. 1, Pos. 6).
110
97
75
37,5
55
566
7,5
Fig. 1 Dimension Diagram of LR 1218 Solar Charge Regulator (dimensions in mm)
Environment
Minimum clearance
Fitting