Operation Manual

EN | 23
EN
• When the subwoofer is paired with the main
unit, the PAIR indicator will light up.
Notes:
• Do not press the Pair button on the rear of the
subwoofer, except for manual pairing.
• If the automatic pairing fails, pair the subwoofer
with the main unit manually.
Manual pairing
1. Ensure that all the cables are well connected
and the main unit is in Standby mode.
2. Press and hold the PAIR button on the rear
of the subwoofer for a few seconds. The sub-
woofer will enter the pairing mode and the Pair Indicator will blink quickly.
3. Press the / SOURCE button on the main unit or the button on the remote control to switch
the main unit on.
4. After the wireless connection succeeded, the PAIR indicator will light up.
5. If the PAIR indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer
and then reconnect the main cable after 3 minutes. Repeat steps 1 - 4.
Notes:
• If the wireless connection fails again, check if there is conict or strong interference (for example,
interference from an electronic device) around your location. Remove these conicts or strong
interferences and repeat the above procedures.
• The subwoofer should be within 6 m of the soundbar in an open area.
• If a TV or an external device is connected, the main unit and the subwoofer will switch on auto-
matically when the TV or the external device is switched on.
• If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator
will ash. Follow steps 1 - 4 above to pair the subwoofer to the main unit.
Basic Operation
Standby/ON
When you rst connect the main unit to the mains socket, the main unit will be in Standby mode. The
POWER Indicator will light up red.
• Press the / SOURCE button on the main unit or the button on the remote control to switch
the main unit on. The status indicator of the last used mode will light up.
• Press and hold the / SOURCE button on the main unit or press the button on the remote
control to switch the main unit back to Standby mode. The POWER Indicator will light up red.
• Disconnect the mains plug from the mains socket if you want to switch the unit off completely.
• When the unit volume is close to mute or is idle for approximately 15 minutes, it will automatically
switch to Standby mode.
Select Modes
Press the / SOURCE button on the main unit or the SOURCE button on the remote control repeat-
edly to switch between AUX, MP3 LINK, OPTICAL and BLUETOOTH
®
modes.
• When AUX mode is selected, the AUX/MP3 LINK Indicator will light up steadily.
• When MP3 LINK mode is selected, the AUX/MP3 LINK Indicator will ash.
Adjusting the Volume
• Press the VOL +/- button to increase/decrease the volume.
• If you wish to turn the sound off, press the MUTE button on the remote control. Press the MUTE
button again or press the VOL +/- button to resume normal listening.
• While adjusting the volume, the status indicator ashes quickly.
Main Unit
Wireless Subwoofer
Wireless Subwoofer