Operation Manual

20 | EN
Note:
• If the unit is in AUX mode, the sleep timer will only switch off the RW 260BT. The external device
must be switched off manually.
Dimmer
The display can be dimmed in 3 levels. To select between the settings press the SNOOZE/SLEEP but-
ton repeatedly while the unit is in standby mode or any of the operating modes.
USB Charger
This unit enables you to charge your phone or other device that can be charged via USB. Simply con-
nect your device to the USB port on the back of the unit.
Notes:
• The USB port on this product is only for charging the batteries of external devices. It cannot play
audio from USB devices.
• A USB device must always be connected directly to the USB port of this product. The use of a
USB extension cord is not supported by this product. The USB port of this product cannot com-
municate with a computer directly.
Radio
1. Switch the unit on as described above.
2. Select radio mode by pressing the STANDBY
/MODE button repeatedly.
3. Select a desired radio station by pressing the or button repeatedly.
4. This unit has an auto store system for quick access: While in radio mode, press and hold for 2
seconds the or button. The whole frequency range will now be scanned and up 20 radio
stations that are found are automatically stored in the memory. Once the scan is nished, you can
quickly select between the stored stations by pressing the Play/Pause button and then the
or button repeatedly.
Note:
• For the best FM reception fully extend the antenna.
Radio Station Presets
Besides the auto store system as described above, you can also manually store radio statione (max.
20 in total):
1. Tune to a radio station which you would like to store.
2. Press and hold for 2 seconds the Play/Pause button. The preset no. (0 - 19) and “MEM” will
be shown in the display.
3. Select a desired preset place from 0 to 19 on which you want to store the current frequency by
pressing the or button.
4. Press the Play/Pause button again to conrm your setting.
5. Repeat steps 1 - 4 to store up to 20 frequencies.
6. To recall a stored frequency, press the Play/Pause button (“CH” will be shown in the display
together with the preset no.) and then the or button until you reach the desired preset.
Notes:
• Manually storing stations on presets where other stations have previously been stored on will
overwrite these.
• Vice versa the auto store system will overwrite previously manually stored stations.
• If a radio station is broadcasting in stereo, “ST” will be shown in the display.