Operation Manual

ENG Page 6 of 10

12 Record Setting

You can set the recording format or audio source before recording. On the main

menu, select “Record Setting” and press the Control Wheel to show the options.

Select the audio source

For the “Source” item, to record voice through the internal microphone, select “MIC”.

To encode external audio source through the line-in cable, select “line in”.

Set the recording quality

(1) Select “Voice Record”, “Line Record” or “FM Record” and press the Control

Wheel to continue.

(2) Select “WAV File” or “MP3 File” and press the Control Wheel to confirm. For

MP3 file, you can turn the Control Wheel to adjust the bit rate. The higher the

bit rate, the better the recording quality but the more space needed.

Set the sensitivity

Set the line-in recording and FM recording sensitivity:

(1) Select “Line Record” and press the Control Wheel to continue.

(2) Select “Sensitivity” and press the Control Wheel to continue.

(3) Move the Control Wheel to adjust the sensitivity degree and press the Control

Wheel to confirm.

13 FM Radio Mode

In the FM radio mode, you can tune in the FM broadcasting station within the specified

frequency range.

Search for station

1. Auto Search

In the “Preset” mode, move the Control Wheel downward and hold it to start auto

scan. “Auto Scan” displays on the LCD. The device will search for all stations

automatically and save the found stations as preset stations. You can press the

Control Wheel to stop the search.

2. Manual Search

(1) Press the Control Wheel to switch to the “Jiggle” mode.

(2) Turn the Control Wheel to adjust the frequency.

(3) When you tune to the station with strong signal, you can save the station as

preset. For detail information about saving station, see the “Save Station”

section.

3. Auto search for station one by one

Press the Control Wheel to switch to the “Jiggle” mode, move the Control Wheel

downward and hold it to start scan. The device begins to search for station, and

then locks at the found station. You can press the Control Wheel to stop the

search.

To resume searching for another station, move the Control Wheel downward and

hold it once again. It goes on searching for the next station and then locks at it.