Operation Manual
EN
EN | 23
FM Radio
1. Press the STANDBY button to switch on the radio.
2. Press the MODE button to switch to FM mode. The display will show “FM” and the
frequency.
3. To automatically search for the next available radio station, rotate and hold for 2 seconds
the SCROLL control. The display will show “Scanning...” and it will stop automatically
once a station has been found (F.6).
4. To manually search for a station, rotate the SCROLL control repeatedly. Each press
adjusts the frequency by 0.05 MHz.
Note:
• To improve the reception, fully extend the antenna and adjust its position, or try moving
the radio to another location.
Scan Setting
This function enables you to search only for stations with strong reception or for all stations
during automatic tuning.
1. In FM mode, press the MENU button to enter the menu and then rotate the SCROLL
control to select “Scan setting”. Finally press the SELECT button to conrm.
2. Rotate the SCROLL control to select “Strong stations”. Press the SELECT button to
conrm the setting. With this setting active, only strong stations will be found during
automatic tuning.
To nd all stations, also those with inferior reception, select “All stations”.
Audio Setting
1. In FM mode, press the MENU button to enter the menu and then rotate the SCROLL
control to select “Audio setting”. Finally press the SELECT button to conrm.
2. Rotate the SCROLL control to select between “Stereo allowed” and “Forced mono”.
Press the SELECT button to conrm the setting.
Note:
• The radio will automatically switch between stereo and mono mode, but you can override
this and switch this function manually which is helpful for poor signal reception.
FM Display Modes
Every time you press the INFO button, the display will cycle through the following display
modes:
Radio Text, Programme Type, Frequency, Audio Type, Power status (Mains/Battery), Time and
Date: