Operation Manual
20 | EN
Clock Setting
The clock in this radio is equipped to receive a DAB radio frequency and RDS time signal. After
the unit has been turned on, it will automatically tune into a DAB radio station (see below) and
update the clock. It may be necessary to wait for 1-2 minutes to allow the unit to receive the
time signal. If there is no DAB or FM-RDS reception it will be necessary to manually set the
clock.
To manually set the clock in standby mode:
1. Power the unit as described above.
2. The display backlight will illuminate for a few seconds, a welcome message (F.1) will
appear in the display briey followed by “00:00:00 Time is not set”.
3. In standby mode, press the ALARM/SNOOZE button. The hour digits will ash in the
display. Rotate the SCROLL control to set the correct hour, then press the SELECT
button to conrm.
4. The minute digits will now ash. Rotate the SCROLL control to set the correct minutes,
then press the SELECT button to conrm.
5. You are now asked to set the date. Rotate the SCROLL control to set day, month and
year, pressing SELECT after each setting to conrm. “Time Saved” will be shown in the
display.
To manually set the clock in working mode:
1. Connect the radio to AC mains (via AC/DC adaptor), then press STANDBY to turn the
radio on.