User manual

51
www.schaerer.com
BASI 2 - EN
Version 04
08.2007
Programming
Programming
Your coffee machine is pre-programmed at the factory. You also have the option, however, of
adjusting the device to your individual tastes. You can program the following product-related
elements (refer also to the programming overview):
Water volume - coffee quantity - pre-brew function
In addition, you can program various device functions individually.
ʇ
If no entry is made during programming, the device automatically switches to the next menu
after 30 seconds and/or switches to “Ready“ mode.
ʇ 7KHGHYLFHFDQRQO\EHSURJUDPPHGLQIRUZDUGPRYLQJVWHSV
ʇ 3URJUDPPLQJLQWKH
level can only be carried out with a PIN code.
The following instructions assume that the machine is ready to operate.
Navigation through the programming level
 $FFHVVWRSURJUDPPLQJOHYHO&RQÀUPSDUDPHWHUVSURFHHGWRWKHQH[WVWHS
= Product settings
= General settings
= System settings
= ncrease or decrease values./ Block or release parameters
Button
[ 1 ]
button
[ 2 ]
Buttone
[ 3 ]
Button
[ 4 ]
1 4
,OOXVWUDWLRQ6WDQGDUGFRQÀJXUDWLRQ
Siena 2
Counter functions in standby mode
Switch the machine into standby mode by pressing the button. Afterwards, you can press
the various buttons to show the respective counter status.
= Total drinks dispensed by machine (all products)
= Double products dispensed
= DECAF drinks dispensed (ground coffee)
= Product counter per product button
= Cleaning counter
= Hot water dispensed
1 4
The factory settings are shown in
bold on the display!