Operation Manual

ManualsBrandsSchaerer ManualsCoffee MakersCoffee Prime

www.schaerer.com Installation and commissioning

BASCP_EN

V03 | 08.2012

DANGER!

Risk of electrocution!

Danger of electric shock!

It is essential that you comply with the following instructions:

• The phase must be fused at the ampere value specified on the serial plate.

• It must be possible to disconnect the device from the mains power supply at all poles.

• Never operate a device with a damaged power cord. Have a defective power cord or plug

replaced immediately by a qualified service technician.

• Schaerer AG recommends against using an extension cable. If, despite this, an extension

cable is used (minimum cross-section: 1.5 mm²), observe the manufacturer data for the

cable (operating instructions) and the locally applicable regulations.

• Route the power cord in such a way that it does not present a tripping hazard. Do not pull

the cord over corners or sharp edges, pinch it between objects or allow it to hang loosely

in the open. Do not position the cord over hot objects, and protect the cord from exposure

to oil and aggressive cleaning products.

• Never lift or pull the device by the power cord. Never pull the plug out of the socket by its

cord. Never touch the power cord or plug with wet hands. Never insert a wet plug into a

power socket.

Power requirements

We reserve the right to make technical changes.

* For special features, see the serial plate as of 2013. The specified values refer to the basic

model.

SCP

Mains Power requirements

Fuse protec-

tion (site

face)

Connecting

cable con-

ductor

cross-sec-

tion

1L, N, PE 220 – 240 V ~ 50/60 Hz 2000-2400 W 10 – 16 A

3 x 0.75 mm²

3 x 1 mm²

1L, N, PE 100 V ~ 50/60 Hz 1350 W 10 – 16 A

3 x 0.75 mm²

3 x 1 mm²

1L, N, PE 110 – 127 V ~ 50/60 Hz 1700 W 15 A 3 x 1.5 mm²

2L, PE 200 V 2~ 50/60 Hz 1800 W 15 A 3 x 1.5 mm²

*SCP Powerpack

Mains Power requirements

Fuse protec-

tion (site

face)

Connecting

cable con-

ductor

cross-sec-

tion

1L, N, PE 208 – 240 V ~ 50/60 Hz 5500-6500 W 25-30 A 3 x 2.5 mm²

2L, PE 208 – 240 V ~ 50/60 Hz 5500-6500 W 30 A

3 x 2.5 mm²

3 x 10 AWG