Operating instructions

BASCP_EN
V02 | 09.2011
11
www.schaerer.comInstallation and commissioning
Installation and commissioning
Setting up the coffee machine
Location
CAUTION!
Risk of machine
damage!
The location where the coffee machine is set up must meet the conditions specified be-
low. If these conditions are not ensured, the coffee machine may become damaged.
The following conditions absolutely must be met:
• The installation surface must be stable and level so that is does not become deformed un-
der the weight of the coffee machine.
• Do not set up the coffee machine on hot surfaces or close to ovens.
• Set up the coffee machine in such a way that it can be monitored by trained personnel at
any time.
• Route the necessary supply connections to within 1 m of the machine location according
to the on-site installation plans.
• Maintain the following clearances for maintenance work and operation:
• Allow enough space above the machine to refill beans.
• Leave min. 15 cm clearance from the rear side of the machine to the wall (air circula-
tion).
• Comply with all applicable local kitchen regulations.
Ambient conditions
CAUTION!
Risk of machine
damage!
The location where the coffee machine is set up must provide the ambient conditions
specified below. If these conditions are not ensured, the coffee machine may become
damaged.
The following conditions absolutely must be met:
• Ambient temperature of +10 °C to +40 °C (50 °F to 104 °F)
• Relative humidity of max. 80 % RH
• The coffee machine is designed for indoor use only. Do not use in the open and never ex-
pose to the weather (rain, snow, subzero temperatures).
If the coffee machine was exposed to subzero temperatures:
► Contact customer service before commissioning.
Power supply
Conditions
The electrical power supply must be connected in accordance with the applicable regulations
(VDE 0100) and the regulations of the country of installation. The mains connection cable type
must be at least H 05 VV-F. The voltage specified on the serial plate must match the supply
voltage at the installation location.
DANGER!
Risk of electrocution!
Danger of electric shock!
The following instructions absolutely must be complied with:
• The phase must be fused at the ampere value specified on the serial plate.
• It must be possible to disconnect the device from the mains power supply at all poles.
• Never operate a device with a damaged power cord. Have a defective power cord or plug
replaced immediately by a qualified service technician.
• Schaerer AG recommends against using an extension cable. If, despite this, an extension
cable is used (minimum cross-section: 1.5 mm²), observe the manufacturer data for the
cable (operating instructions) and the locally applicable regulations.
• Route the power cord in such a way that it does not present a tripping hazard. Do not pull
the cord over corners or sharp edges, pinch it between objects or allow it to hang loosely