Operation Manual

BASCJ_EN
V02 | 08.2012
19
www.schaerer.comOperation
Hot water
Three different dosing variants are available for dispensing hot water:
► Place a cup under the hot water outlet.
► Adjust the height of the beverage outlet to the cup size.
CAUTION!
Hot fluid!
Option 1: Dosed
► Press the button.
 The set quantity is dispensed.
Option 2: Freeflow
► Press and hold the button.
 Dispensing takes place while the button is pressed.
Option 3: Start/stop
► Press the button.
 Hot water is dispensed.
► Stop dispensing by pressing the button again.
Hot milk
Hot milk and milk foam are dispensed using the same button. Milk is dispensed when the outlet
is all the way up. Milk foam is dispensed when the outlet is in a lower position.
► Place a cup under the beverage outlet.
► Slide the beverage outlet to the highest position.
 Air is always added to the milk unless the outlet is in the highest position.
CAUTION!
Hot fluid!
► - Press the button.
 Hot milk is dispensed.
Milk foam
Hot milk and milk foam are dispensed using the same button. Milk is dispensed when the outlet
is all the way up. Milk foam is dispensed when the outlet is in a lower position.
► Place a cup under the beverage outlet.
► Push the beverage outlet down as far as possible.
CAUTION!
Hot fluid!
► - Press and hold the button.
 Dispensing takes place while the button is pressed.
Double beverage
Two beverages can be dispensed at the same time. This only applies to espresso, café creme
and cappuccino.
► Place two cups under the beverage outlet.
► Adjust the height of the beverage outlet to the cup size.
See "Dispensing options" - "Stop dispensing" to stop dispensing of the beverage.
The service technician can deactivate unrequired dosing variants or adjust the dosing quantity
of the "dosed" variant.
If dispensing is not stopped manually by pressing the button, dispensing ends automati-
cally after a defined time period. This can be defined by the service technician.