Operating instructions

www.schaerer.com Operation
BASCJ_EN
V01 | 02.2011
16
► Remove and rinse the milk container.
► Fill in fresh, pre-cooled milk (3 – 5°C).
► Place the milk container into the cooling unit.
► Hang the hose or hoses into the container.
 The hose end must be in contact with the container floor.
► Close the door.
Switching on
► Press the button.
 The coffee machine switches on and the greeting message appears on the display.
► Place a container under the beverage outlet.
 The coffee machine begins heating up.
 After heating up, the coffee machine performs a coffee system rinse (duration:
ca. 40 sec).
Option: Additional cooling unit
► Connect the additional cooling unit to the line supply.
► Set the rocker switch on the rear of the additional cooling unit to "COLD".
 The additional cooling unit switches on.
Dispensing
Preheating cups
A storage area for cups is located on top of the coffee machine. When the machine is switched
on, the storage area is heated and the cups are prewarmed.
► Place the cups on the storage area.
 The cups are pre-warmed when the coffee machine is switched on.
Adjusting outlets
CAUTION!
Hot surface!
Hot surfaces can cause burns.
Exercise care when moving the beverage outlet.
► Place a cup under the beverage outlet.
► Grasp the beverage outlet from the front and slide it into the correct position (see figure).
► Remove the cup after the beverage has been dispensed.
See "Operation" - "Fill and connect" - "Milk" - "Option: additional cooling unit".
Adjustable height = 70 – 135 mm.