Operation Manual

27
www.schaerer.com
User Manual SCF - EN
03.2010 / Edition 07
Software
Descaling
Insert the water tank lled with descaling solution, 
and conrm on the display
Descaling begins. This part of the routine takes
about 40 min.
Remove water tank and empty out remaining 
descaling solution
Rinse water tank and ll to maximum with cold water 
Replace the water tank 
Rinsing
Rinsing begins. After the initial rinse from the water tank,
the display requests that the water supply be turned on
again. This part of the routine takes about 40 min.
Turn on mains water tap 
Leave the water tank in place. The water tank connector
is rinsed for approximately 10 seconds from the mains
supply.
Remove water tank and dry 
Turn and remove seal plug on water tank connector in 
a clockwise direction
(at screwdriver, see illustration 1 and 2)
Replace the water tank 
Subsequent rinses are from the mains supply.
After the nal rinse, the steam boiler is heated. The hot
water expands and nally exits briey as steam.
The descaling is complete. Completion is indicated on
the display.
Filter change
If the lter capacity is exceeded, there will be a message
once per day that a lter change is due.
The lter must be changed within one week; otherwise,
the message will be displayed after every brew.
Change lter 
Conrm lter change 
After lter change there is an automatic program
sequence to rinse and bleed the anti-scale lter and
water system. Hot water runs out of the hot water spout
during this process.
Illustration 1
Illustration 2
Caution.
Hot steam.
Observe the Safety
chapter.
Observe water lter
instruction.
Displays lead step by step
through the program.
Follow the instructions.
Caution.
Scalding hazard.
Observe the Safety
chapter.