User manual

Operation
BASCC BC - 02.04 - V01 Page 4-7
4.5.5 Dispensing Hot Water
Press the Tea product field on the control panel
to dispense hot water (see Fig. 019).
Depending on the configuration, the output is either dosed or manual (Start / Stop)
via the hot water pipe located to the left next to the coffee outlet (see Fig. 020).
In self-service mode, products are selected via an external button directly above the
hot water pipe.
- Hot water cannot be pre-selected.
- Coffee and hot water can be dispensed simultaneously.
Danger!
Risk of injury by scalding! Keep hands and other body parts away from the
outlet!
If portioned delivery is programmed:
1. Place an empty cup under the hot water outlet
(see Fig. 020).
2. Touch the Tea product field (Fig. 019).
3. To cancel the current output:
Press the STOP button.
Note:
If, after output of an appropriately large amount of hot
water, the message "Under-Temperature Tea"
appears, it means that the boiler is being heated up to
the set temperature.
If start / stop mode is programmed:
1. Place an empty cup under the hot water outlet
(see Fig. 020).
2. Touch the Tea button (Fig. 019).
The hot water is delivered continuously.
3. Press the Tea button again or the STOP button
to end the hot water output or to cancel.
Fig. 019
Fig. 020